Pride Mobility Jazzy 1143 - Manual (Page 12)

Jazzy 1143 12
I V . C O M F O R T A D J U S T M E N T S
Figure 7. Armrest Width Figure 6. Seat Height Adjustment
SEAT PEDESTAL
HEX HEAD NUT AND BOLT
After you have had your Jazzy for an extended period of time, you may find the need to adjust the seat. There are
some adjustments you can make to increase your comfort such as seat height and armrest angle. If your Jazzy 1143
was configured at your local Pride provider or service center, please consult your health care professional before
changing seat position or before making any other adjustments. Some of these adjustments may decrease your
Jazzy’s performance and safety by changing its center of gravity.
Seat Height
You can change the seat height to one of three positions in 2.5 cm increments.
To change the seat height:
1. Remove the seat. See V. “Disassembly.”
2. Remove the shroud.
3. Use two 9/16-in. wrenches to loosen and remove the hex head nut and bolt. See figure 6.
4. Use a 5/32-in. hex key and a 7/16-in. wrench to loosen the nut and bolt on the rear of the seat pedestal base.
5. Slide the seat pedestal up or down in the seat pedestal base.
6. Align the holes on the seat pedestal and the seat pedestal base.
7. Reinstall the hex head nut and bolt, and tighten.
8. Reinstall the nut and bolt on the rear of the seat pedestal base, and tighten.
ARMREST WIDTH
To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See figure 7.
2. Loosen the knobs; slide the armrests in or out to the desired width.
3. Retighten the knobs.
LOOSEN KNOB TO MOVE ARMREST