PYLE Audio PLHR7SP - Manual (Page 8)

CAUTION: make sure the screws are not long enough to go through
the headrest!
If you have any doubtsabout this typeof installation,please consult
your local mobile electronics retailer. Cutting and making holes in
the headrest will causeelectronic damage which is expensive to repair.
Setup work
Remove the headrest and set it in an uncluttered
work area. Pay the appropriate precautions to
ensure that it is not damaged during the installation.
Steps For Installing Headrest with Shroud
Measurements
Press the headrest with your fingers to make
sure there are no obstructions that would hinder
the installation. Use paper template to mark the
area to be cut.
Cut the headrest
Use an adjustable-depth blade, start
your cut 1/4 inch inside one corner and
cut diagonally across, stopping 1/4 inch in
from the other corner. Repeat this procedure
for the other two corners.
Remove foam & obstructions
Carefully peel off the material. Set the
adjustable blade to one inch depth and cut
around the edges of the hole, staying 1/4 inch
inside the edge. Pull up one corner of the foam
and use the blade to cut underneath. Remove
small section at a time and ensure to be the
uniform depth. Use a dremel or other appropriate
tools to remove other obstructions. Insert the monitor to
measure the fit and make adjustment if necessary
7