PYLE Audio PLHR7SP - Manual (Page 10)

Steps For Installing Sun-visor with Shroud
Setup work
Remove the visor and set it in an uncluttered
work area. Pay appropriate precautions to
ensure that it is not damaged during the installation.
Measurements
Press push on the headliner with your fingers to make
sure there are no obstructions that would hinder
the installation. Use paper template to mark the
area to be cut.
Cut the visor
Use an adjustable-depth blade, start
your cut 1/4 inch inside one corner and
cut diagonally across, stopping 1/4 inch in
from the other corner. Repeat this procedure
for the other two corners.
Remove foam & obstructions
Carefully peel off the material. Set the
adjustable blade to one inch depth and cut
around the edges of the hole, staying 1/4 inch
inside the edge. Pull up one corner of the foam
and use the blade to cut underneath. Remove
small section at a time, ensure to be the
uniform depth . Use a dremel or other appropriate
tools to remove other obstructions. Insert the
monitor to measure the fit and make
adjustment if necessary.
CAUTION: make surethe screws are not long enoughto go through
the visor!
If youhave any doubts about this type of installation, please consult
yourlocal mobile electronics retailer. Cutting and making holes in
the visor will cause electronic damage which is expensive to repair.
9