PYLE Audio PLHR7SP - Manual (Page 11)

Route the cable through the visor
Run the supplied cable through the opening
and out to the bottom of the visor. If possible,
conceal the wires using a shaft covering.
Connect the power, ground and video leads to
test the MONITOR.
Before connecting the monitor, pull the
connecting cable assembly through the
visor housing as shown in diagram. Place
visor housing into the opening and secure with
correct fasteners.
Install the sun-visor housing
Pull the connecting cable through the center of
the housing as shown in diagram, and secure with
correct fasteners
Insert the monitor
Push to insert the monitor
to the headrest housing.
Oper ate your syst em in a saf e and legal manner
When oper ate a motor vehi cle, it shoul d always be your highest priority to
maintain saf e driving habi ts.
It is illegal in many areas of most count ries to drive with TV or MONITOR
on, when it is visible to the driver. Please check your local and state
laws gover ning the use of MOBILE ENTERTAINMENT SYSTEM in your area.
Removal
visor shroud gap and pull it out to remove the
monitor from headrest shroud.
Insert the release key between the monitor and
10