Polaris 800 Switchback - Manual (Page 74)

72
MAINTENANCE
Lubrication
Jackshaft Bearing Greasing
Loosen the driven clutch retaining bolt and pull
the clutch outward to expose the bearing and
grease fitting. Inject grease into the grease
fitting in the flangette until grease purges from
inside or outside the bearing seal (may take
only two pumps). Push the clutch back onto
the shaft and replace the clutch retaining bolt.
Torque to 18 ft. lbs. (24.4 Nm).
Driveshaft Bearing Greasing
Inject grease into the fitting on the speedometer
drive adaptor until grease purges from inside or
outside the bearing seal (approximately two
pumps).
Throttle Cable
Lubricate the throttle cable (1) lightly with
grease or oil. With the engine off, turn the
handlebars to the left and lubricate liberally
as shown.
Choke and Cable
Lubricate the choke slide (2) and cables
lightly with oil or grease. Before turning the
engine off, operate the choke intermittently
to draw moisture out of the choke plunger
area and reduce the possibility of the choke
becoming frozen.
+
+
+
1
2