Sound settings, User preferences, Digital output – Philips DVDR 77/00 User Manual
Page 102: Analogue output, Night mode
94
Sound settings
Depending on which audio outputs are used, you can select the settings in this menu.
If you only use the analogue audio output ( AUDIO L/R OUT ), select the settings 'Off' in the
'Digital output' menu.
Sound
Digital output
All
Analogue output
Stereo
Night mode
Off
'
Digital output'
You can select one of the following settings for devices that are connected to the COAX
OUT or OPTICAL AUDIO OUT sockets:
'
All': Dolby Digital and DTS signals are fed unaltered to the digital output. MPEG-2 multi-channel
signals are converted to PCM (Pulse Code Modulation).
For receivers/amplifiers with digital multi channel sound decoders.
'
PCM only: Dolby Digital and MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers without digital multi channel sound decoders.
'
Off: Digital output switched off.
For devices with analogue audio input.
'
Analogue output'
For devices connected to the analogue audio output ( AUDIO L/R OUT ), you can select from
the following settings.
'
Stereo': For devices without DolbySurround or TruSurround. Use this setting if the DVD
recorder is only connected to a stereo TV set.
'
Surround: Dolby Digital and MPEG-2 multi-channel are mixed down to a DOLBY
surround-compatible two-channel output signal.
For devices with Dolby Surround Pro Logic decoder .
'
Night mode'
Night mode optimises the sound for playback at low volume. You are therefore less likely to
disturb your neighbours. This only works for Dolby Digital audio on DVD video discs.
User preferences