Pella Replacement Window 80YV0102 User Manual

Page 5

C. Remove Interior Frame Cover #2.

The cover on vent units where the crank handle and roto-cover will be located.

For Standard Awning, single units greater than 42" in height and multiple window

combinations.

1. Starting at the cover end

closest to where the crank

handle will be located, insert

the tool between the sash and

cover (using the same method

of insertion used for Interior

Frame Cover #1).
Note: Insert the tool under

Interior Frame Cover #2 next

to the FRAME CORNER (C2).

2. Pull the tool away from the frame to start releasing the cover barbs from the frame kerfs.

3. When the cover begins to pull away from the frame, relocate the tool near the end of

the cover as shown and continue to pull up to release the barbs from the kerfs.

4. When the cover has been released near the crank handle cut-out, reposition the tool

with the hook under the front edge of the cover. Slide the tool over while pulling up on

the cover. Continue along the length of the cover until it is removed.

NOTE

Cover support bracket

AWNING/

CASEMENT

D. Remove Interior Frame Cover #3.
The cover on vent units on the opposite frame side from where the crank handle is located.

For Standard Awning greater than 42" in width, single units greater than 42" in height and

multiple window combinations.

1. Start at one end of the cover and insert the tool

between the frame and cover as shown.

2. Pull the tool away from the frame to start releasing the

cover barbs from the frame kerfs.

3. When the cover begins to pull away from the frame, grasp

the cover and continue to pull to release the barbs from

the kerfs, removing the cover.

TWO OR MORE PEOPLE ARE REQUIRED FOR THE FOLLOWING STEPS

Note: Take note of the cover

support bracket around the

roto operator hardware, (on

the sill of casement and

large awning units and on

the jamb of standard awning

units) as the cover support

bracket will be referenced

when re-installing Interior

Frame Cover #2.