Pella HINGED PATIO DOOR - SOUTHWESTERN WALL WITH HARD COAT STUCCO 80KM0103 User Manual

Page 5

INTEGRATING THE DOOR TO THE BUILDING FELT

Note: The ﬂashing tape must be applied approximately 1/2" onto the frame cladding at the jambs and
head. Pre-folding the tape at 1/2" before removing the paper backing will make it easier to apply the
tape correctly. If the siding is less than 1/2" thick, adjust the dimension of the fold so the exterior sealant
line will cover the exterior edge of the tape.

A. Apply side ﬂashing tape.

TAPE

B. Apply top ﬂashing tape. Cut a piece of ﬂashing tape long enough to go across

THE

C. Apply the top ﬂashing paper.

width of the rough opening. Position the bottom edge of the ﬂashing paper ﬂush with the
frame of the door and center the ﬂashing paper with the door. Staple the ﬂashing paper to
the header.

Note: When applying the ﬁrst layer of building felt, ensure the sill ﬂashing paper
overlaps the building felt. This will tie the door system into the building water
management system.

&YUFSJPS

INTERIOR SEAL

Caution: Ensure use of low pressure polyurethane window and door installation foams and strictly follow the foam manufacturer’s
recommendations for application. Use of high pressure foams or improper application of the foam may cause the door to bow and
hinder operation. DO NOT use ﬁberglass insulation.

A. Apply insulating foam.

&ROM

*OUFSJPS

{

B. Check the door operation by opening and closing the door.

Note: If the door does not operate correctly, check to make sure it is still plumb, level, square and
that the sides are not bowed. If adjustments are required, remove the foam with a serrated knife.
Adjust the shims, and reapply the insulating foam sealant.