Pella HINGED PATIO DOOR - SOUTHWESTERN WALL WITH HARD COAT STUCCO 80KM0103 - Manual (Page 3)

2
SETTING AND FASTENING THE DOOR
A. Remove plastic wrap and cardboard packaging from door. DO NOT remove plastic
SHIPPING
B. Fold out installation fin to 90°.
Note: If the fin is not at 90°, the door will not line up correctly on the interior.
C. Place three 3/8" beads of sealant.
THE
TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS.
D. Insert the door
the door into the opening. Sliding will damage the sealant lines. Place the bottom
of the door at the bottom of the opening, then tilt the top into position. Center the
door between the sides of the opening to allow clearance for shimming, and insert
ONE
E. Plumb and square door.
DOOR
F. Check the interior reveal.
to the interior face of the wall is equal at several points around the door.
Note: If the dimensions are not equal, check to make sure the fins are folded out to 90°
at all points.
У
У
&YUFSJPS Ó
&YUFSJPS
Ó
*OUFSJPS
У
У
У
£
У д О д
{ д x д
И д З д
У
О
- ““
У