Panasonic CF-Y4 - Manual (Page 58)

Hard Disk Backup Function
58
Im
po
rta
nt Info
rma
tion
and data>
Select [2], enter the partition size (GB), and press the Enter key.
• You can cancel this operation by pressing the 0 key.
• The data partition size will be the maximum settable size less the
number entered above.
The maximum settable size will differ depending on models.
H At the confirmation message, press the Y key.
The backup area is then created.
I When the message [You must reboot in order to enable the Backup func-
tion.] appears, remove the Product Recovery DVD-ROM, and press any
key to restart the computer. The computer is restarted, then the backup
process will begin.
J When the message [[Backup] is complete] appears, press the Ctrl + Alt
+ Del key to restart the computer.
z
Do not press the Ctrl + Alt + Del key until the message is displayed.
K After logging on to Windows, a message will appear advising that a new
device has been installed and that the computer must be restarted to
enable the settings. Select [Yes] to restart the computer.
NOTE
z The [Boot] menu in the Setup Utility is set to start up from the DVD-ROM & CD-
R/RW drive. Change this setting if necessary.
z The next time the backup or restore functions are executed, follow the proce-
dure for [Backing Up and Restoring Data].
CAUTION
z Before executing the backup function, execute a disk error check (Î page 56).
z Do not interrupt the backup or restore functions before completion, for example
by turning off the power or pressing the Ctrl + Alt + Del key, as this may pre-
vent Windows from starting up, or may cause data to be lost so that the backup
and restore functions cannot be executed.
A Turn the computer on, and press the F2 key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password or the User
Password.
Backing Up and Restoring Data