Polycom DVD 729 - Manual (Page 20)

20
3139 246 12911
Setup Menu
Reverb Mode
The REVERB MODE can stimulate the echo and
frequency response of some particular places to
make you feel like personally on the place.
1 Press the 34 keys to highlight the REVERB
MODE.
2 Enter its submenu by pressing the
2 key.
3 Move the cursor by pressing the
34 keys to
highlight the selected item.
➜ OFF: Playback a disc in original sound effect.
4 Press OK.
5 Press the
1 key to return to the DIGITAL
OUTPUT SETUP menu.
Digital Audio Setup menu
In this menu, you can set up the digital audio
output signal from the digital terminals, such as
coaxial or optical etc.
1 Press SYSTEM MENU to enter the SETUP
menu.
2 Press the 34 keys to choose the DIGITAL
OUTPUT SETUP.
3 Press OK.
Digital Output
1 Press the
34 keys to highlight DIGITAL
OUTPUT.
2 Enter its submenu by pressing the
2 key.
3 Press the
34 keys to highlight the selected item.
➜ ALL: Original digital signals output.
➜ PCM ONLY: If your receiver is PCM-
compatible, or your receiver can not decode
MPEG-2, Dolby Digital, or DTS audio, choose
this option.
4 Press OK.
5 Press the 1 key and return to the DIGITAL
OUTPUT SETUP menu.
Note:
– If DIGITAL OUTPUT is set to ALL, all audio
settings except MUTE are invalid.
LPCM Output
If you connect the DVD Player to a PCM
compatible receiver via the digital terminals, such
as coaxial or optical etc, you may need to adjust
LPCM OUTPUT.
Discs are recorded at a certain sampling rate.
The higher the sampling rate, the better the
sound quality.
1 Press the
34 keys to highlight the LPCM
OUTPUT.
2 Enter its submenu by pressing the
2 key.
3 Move the cursor by pressing the
34 keys to
highlight the selected item.
➜ 48K: Playback a disc recorded at the sampling
rate of 48kHz.
➜ 96K: Playback a disc recorded at the sampling
rate of 96kHz.
4 Press OK.
5 Press the 1 key to return to the DIGITAL
OUTPUT SETUP menu.
01-28 DVD728 Eng 18/03/2003, 5:41 PM 20