Polaris 9919078 - Manual (Page 45)

42
THE PERFECT FIT
Edge Touring Suspension (ETS) Adjustments
Torsion Springs
Two torsion springs are used on the rear arm of
the ETS. Preload adjustments can be made by
turning the rectangular adjusters with a spark
plug wrench.
The firm torsion spring should be used if
frequent bottoming is encountered during two
up riding on rough trails.
The soft torsion spring should be used for
frequent one up riding on smooth trails.
For soft tension, position the long end of the
cam to the front (A). For firm tension, position
the long end of the cam up (B).
Front Track Spring and Preload
Front track spring and preload can also be
adjusted. Turn the screw (C) clockwise to
tighten compression (stiffen). Turn the
spring (D) clockwise to tighten preload.
Initial Setup Reference Chart
This chart is only a guideline for initial suspension setup. Your setup
may vary based on your desired riding style.
Torsion
Spring & Block
Setting
RCA
Position
Front Track
Spring Preload
(Inches)
Front Track
Indy Select -
Turns From
Full Open
1 Rider Soft
Firm
Low
Med
1-2
2-3
0.25
0.50
0-1
1-2
2 Riders Soft
Firm
Med
High
3-4
4-5
0.75
1.00 max
1-3
2-3
Optional Torsion Spring Optional Front Track
Spring
Left Hand Right Hand
Soft
Firm
7042139-067
7042282-067
7042140-067
7042283-067
7041351-067
-------------
A
B
C
D