Polaris Scrambler 9921777 - Manual (Page 39)

36
FEATURES AND CONTROLS
All Wheel Drive (AWD) System
The All Wheel Drive system is
controlled by the AWD switch.
When the switch is on 2X4, the
ATV is in two-wheel drive at all
times. When the switch is on
AWD, the ATV is in all wheel
drive and the AWD indicator light
will be on.
When in AWD, the front hubs
will automatically engage any time the rear wheels lose traction. When
the rear wheels regain traction, the front hubs will automatically disen-
gage. There is no limit to the length of time the vehicle may remain in
AWD.
Tip: The override switch allows activation of AWD in reverse if the AWD switch
is on.
Engaging AWD
The AWD switch may be turned on or off while the vehicle is moving.
Initially, the vehicle's electronic system will not enable the AWD until
the engine RPM is below 3100. Once enabled, the AWD remains
enabled until the AWD switch is turned off. If the switch is turned off
while the front hubs are moving, the hubs will not disengage until the
rear wheels regain traction.
Engage the AWD switch before getting into conditions where front
wheel drive may be needed. If the rear wheels are spinning, release the
throttle before switching to AWD.
NOTICE: Switching to AWD while the rear wheels are spinning may cause
severe drive shaft and gearcase damage. Always switch to AWD
while the rear wheels have traction or are at rest.
AWD
Switch