Philips SCD510/00 - Manual (Page 11)

Reset function
This function allows you to reset the parent unit and the baby unit to the default settings. You can
use this function if problems occur that you cannot solve by following the suggestions in chapter
‘Frequently asked questions’. You have to reset each unit separately.
1 Press the on/off button to switch off the parent unit. Remove the small plug from the parent
unit and the adapter from the wall socket (Fig. 1).
Press and hold the volume down (-) button. Put the small appliance plug in the parent unit
and put the adapter in the wall socket (Fig. 6).
Wait for the parent unit to complete its automatic restart at its default settings before you
release the volume down (-) button.
Proceed in the same way to reset the baby unit.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Baby unit
Loudspeaker volume: medium
Nightlight: off
accessories
Belt clip
If the batteries of the parent unit are sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt with the belt clip. This allows you to monitor
your baby while you are moving around.
Connecting the belt clip
1 Snap the belt clip onto the parent unit (Fig. 27).
Disconnecting the belt clip
1 Pull the belt clip off the parent unit.
Cleaning and maintenance
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit or the parent unit if they are connected to the mains.
Clean the parent unit and the baby unit with a damp cloth.
Make sure the units are dry before you connect them to the mains.
Clean the adapters with a dry cloth.
Storage
When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and the rechargeable batteries from the parent unit. Store the
parent unit, the baby unit and the adapters in a cool and dry place.
-
-
-
-
-
EngliSh 11