Troubleshooting – Pentax 67II User Manual
Page 78
OTHERS
76
Troubleshooting
What appears troublesome may be easily remedied. Here are some problems that may occur and
their remedies. Before contacting a Pentax service center, check the following items.
Symptoms
Causes
Remedies
Reference
The shutter cannot be
released.
The last frame is exposed.
Remove the film.
The main switch is set to d.
Set the main switch to i.
The low battery warning H
appears.
Replace the batteries.
The Self-Timer Mode is set.
Cancel the Self-Timer Mode.
The film is not winded.
Wind the film.
Indicators do not appear on
the LCD panel.
The main switch is set to d.
Set the main switch to i.
No batteries have been installed.
Install the batteries.
The batteries are improperly
installed.
Install the batteries properly.
The batteries are dead.
Replace the batteries.
Focus is not precise in the
picture.
The pressure plate has not been set
to the proper position.
Set the pressure plate according to
the film type.
Film winding is very heavy.
The pressure plate has not been set
to the proper position.
Set the pressure plate according to
the film type.
The first frame (or the last
frame) was cut off on the film.
The film start mark had not been
properly set.
Set the film start mark to the proper
position.