Plinius Audio TIKI Network Audio Player - Manual (Page 9)

7 NETWORK AUDIO PLAYER
Front Panel Functions
1. DISPLAY LED
An LED on the front panel indicates that the power is on. When first switched on, the
display LED will immediately light and will remain lit during the time the network audio
player is powered on.
Rear Panel Functions
This panel incorporates the terminal for connecting the input signal from a Network
storage device, outputs to the preamplifier, ground lift switch and also the mains
supply. Please remember that your Plinius Tiki Network Audio Player is a high quality
electronic instrument. Be sure that you understand your system’s requirements fully
before you make any connection to this network audio player.
1. OUTPUT TERMINALS
Connections for preamplifiers or integrated amplifiers are provided on the rear panel.
Connections are available for analogue single ended RCA and balanced XLR cables.
The XLR output pin configuration used in all Plinius product is:
PIN 1 to GND
PIN 2 to +Signal
PIN 3 to –Signal
NOTE: Because of the way balanced XLR outputs are configured it is not possible to
connect both XLR and RCA at the same time.
1
1 1 2
3
5 4