Psion Teklogix PrintAbout MP2000 - Manual (Page 51)

Specifications
Media Specifications
Receipt Paper
General Specifications: 0.0022 to 0.0065” (0.056 to 0.089mm) Thick
2.9 to 4.125” (73.66 to 104.78mm)Wide
1.75” (44.45mm) Maximum Outside Diameter
0.750” (19.05mm) Core Diameter Recommended
Black Mark Sensing On Printed Side
Approved Vendors: Kansaki: P300, P310, P350, P354, P390*, P530UV, TO281CA,
OP200, TO381N, F180, F380, F550
Jujo: TF-50KS-E2C
Honshu: FH65BV-3
Appleton: Resiste 900-3.0*
*Standard Psion Teklogix Offering
Black Mark Position
For automatic ticket printing, the black mark should be positioned as shown in the figure below. When using
Mark Sensing mode, PrintAbout printers will automatically position the output for tear-off and printing
following a Form Feed command or by pressing the Paper Feed button.
For non-automatic paper positioning, refer to the MLP Series & PrintAbout Programmer’s Manual for sensing
and positioning commands.
0.15”
Black Mark should span width
of paper for best results.
Perforation or tear position
Figure 17 - Black Mark Position
45