Psion Teklogix PrintAbout MP2000 - Manual (Page 29)

Printer Configuration
Print All Logos In Memory
This menu item is only available using Control Panel Setup and is only available if downloaded fonts and/or
logos are currently stored in the printer’s memory. Selecting this item causes the printer to print out a directory
of all fonts and logos, and to print a copy of all logos.
Options Menu
The Options Menu contains features that affect the overall operation of the printer.
Note: Factory default values are indicated by an asterisk (*).
Left Paper Guide Adjust
Possible Values: A*, B through G
This feature is used to match the leftmost print position with the location of the Left Paper Guide. For a
complete description, please refer to the Right Paper Guide, below.
Right Paper Guide Adjust
Possible Values: None*, 1 through 9
Similar to the Left Paper Guide, this feature is used to match the rightmost print position with the right edge of
the paper.
The positions of the paper guides are used to adapt the PrintAbout to be used with different widths of paper. To
provide maximum flexibility for various paper widths and black mark positions, any combination of left and
right guide positions may be used. Paper widths less than 2.9” are not recommended.
For instance, to use the standard four inch paper (4.125”), the Left Paper Guide would be located at position
“A” as shown in Figure 12, below, and the Right Paper Guide would not be installed (None). To use standard
three inch paper (3.125”) the Left Paper Guide would be installed at “A” and the Right Paper Guide would be
installed at position “7”.
To remove a paper guide, simply pull the guide out of the printer’s paper compartment. To install a paper
guide, insert the end toward the rear of the printer first as shown in Figure 12 and then “snap” in the end toward
the front of the printer. When selecting guide positions, select positions that are as close to the end of the paper
roll as possible, but not so tight that the paper cannot unroll easily.
23