Psion Teklogix PrintAbout MP2000 - Manual (Page 11)

Getting Started
Installing Media
Each printer comes supplied with a roll of receipt paper.
Note: For maximum performance and optimum print quality, use only genuine Psion Teklogix media in
your PrintAbout printer.
To install media, you must release the paper door by moving the Paper Door Release Lever in the direction
shown in Figure 4 and then lift the paper door to expose the paper compartment.
Paper Door
Release Lever
Figure 4 - Opening Paper Door
Unroll a small portion of the paper as shown, place the roll into the printer, and close the Paper Door. If the
printer is turned on, you may now press the Paper Feed Button to advance the paper and then tear it off in
preparation for printing.
Note: If you need to use a paper width other than what was supplied with your printer, please refer to
Media Specifications in the Specifications section of this manual.
5