Philips 14PV385/07 - Manual (Page 13)

11 EN
General information
Use ‘Manual recording’ to make a spontaneous
recording (for example, a programme currently
being shown).
If you want to start and stop a recording manual-
ly, read the section ‘Recording without auto-
matic switch-off’.
If you want to start a recording manually but
have it stopped automatically, read the section
‘Recording with automatic switch-off’. (e.g.
not to record to the end of the tape)
Read the section ‘Automatic controlled
recording from a satellite receiver (RECORD
LINK)’, if you want a recording to be controlled
automatically by a satellite receiver.
Recording without automatic switch-off
1. 1.Insert a cassette.
2. 2.Use or to select the programme
number you want to record, for example,
‘P01’.
3. 3.To start recording, press .
4. 4.To stop recording, press .
Recording with automatic switch-off
(OTR One-Touch-Recording)
1. 1. Insert a cassette.
2. 2. Use or to select the programme
number you want to record.
3. 3. Press .
4. 4. Each time you press you will add 30 min-
utes to the recording time.
5. 5. To stop recording, press .
Preventing accidental erasing
All cassettes (except rental
and pre-recorded cassettes)
have a security tab on the
back of the cassette.
To prevent recording over
important recordings (eras-
ing), you can remove this security tab.
If you later decide to record on a protected cas-
sette, simply cover the hole with adhesive tape
or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette,
which already has a recording on it, a short blank
(flicker) can appear between the old and the new
recording or the picture itself can flicker. To help
reduce these from occurring, proceed as follows:
1. 1. Find the tape position of the old recording
where you want to insert the new recording.
2. 2. Look at the last minute of the old recording
(playback).
3. 3. Press at the tape position where
the new recording is to go and press .
4. 4. Now start recording as usual by pressing
on the remote control.
5. 5. Stop recording with . STOP C-L
REC I
REC I
STILL 2 2
STOP C-L
REC I
REC I
0..9 P– P+
STOP C -L
REC I
0..9 P– P+
6. Manual recording
The message ‘PROTECTED CASSETTE
CANNOT RECORD’ appears briefly on the
screen, then the cassette is ejected.
A cassette without its security tab had been
inserted. Cover the hole with adhesive tape or
insert a new cassette.
T6450EZ(EN)_UKX.qx3 04.2.12 9:23 PM Page 13