Pioneer DVR-433H-K - Manual (Page 49)

Recording 05
49
En
Check that the Audio In settings for External Audio ,
Bilingual Recording and DV Input are as you want them
(see Audio In Settings on page 94).
• If the aspect ratio is distorted (squashed or
stretched), adjust on the source component or your
TV before recording.
3 Set up the recorder.
• Use REC MODE ( SHIFT + ) to set the recording
quality. See Setting the picture quality/recording time
on page 39 for detailed information.
• Use the HDD/DVD button to select the HDD or DVD
for recording.
4 Press ì REC when you’re ready to start
recording.
• The recorder will only start recording from the DV IN
jack if there is a valid signal. Recording will also
pause if the signal is interrupted during recording.
• If your source is copy-protected using CopyGuard,
you will not be able to record it. See Restrictions on
video recording on page 38 for more details.
Automatic recording from a satellite
tuner
If you have a satellite tuner or some other kind of set top
box connected to the
AV2/AUTO START REC (INPUT 1/
DECODER) input, you can have the recorder start and
stop recording automatically with the timer settings of
the connected component. (If the other component
doesn’t have a built-in timer, you’ll need to use it with an
external timer unit.) 1
After setting up for Auto Start Recording, this recorder
starts recording when it detects a signal from the other
component. When the signal ceases, the recorder stops
recording.
If you want to use this recorder with the timer features of
your satellite tuner, see
Language code list on page 108.
Important
• It takes a little while for this recorder to switch on and
start recording after detecting a signal. Please bear
this in mind when setting the timer.
• If Auto Start Recording is set, it will not start if
another timer recording is in progress.
• Timer recordings take precedence over Auto Start
Recording. Auto Start Recording will stop if a timer
recording is due to start. After the timer recording
has finished, Auto Start Recording will resume.
1 Set the timer for the satellite receiver (or other
component), then switch it into standby (if
necessary).
Check the manual that came with the receiver if you’re
not sure how to do this.
2 Check that the ‘Audio In’ settings for ‘External
Audio’ and ‘Bilingual Recording’ are as you want
them.
See Audio In Settings on page 94 for more on these
settings.
3 Set up the recorder.
• Use REC MODE ( SHIFT + ) to set the recording
quality. See Setting the picture quality/recording time
on page 39 for detailed information.
4 Press HOME MENU and select ‘Timer Recording’,
then ‘Auto Start Recording’.
5 Select ‘Yes’ to switch Auto Start Recording on, or
‘No’ to switch off.
6 Switch the recorder into standby.
The AUTO indicator in the front panel display lights.
The recorder will automatically switch on and start
recording when the other component comes on.
Recording stops when the external component switches
off.
• To cancel Auto Start Recording, press STANDBY/
ON while the recorder is in standby. The AUTO
indicator goes off.
• To cancel Auto Start Recording once recording has
already started, press
ì REC for three seconds (this
cancels Auto Start Recording, but recording
continues), then
STOP REC to stop recording.
• You can also stop recording by pressing STOP REC
then selecting Yes to confirm.
Tip
• Alternatively, with no OSD displayed, press and hold
the front panel STOP REC button for more than
three seconds to switch Auto Start Recording on
directly. After switching on, switch the recorder into
standby (step
6 ).
Note
1.You can’t set Auto Start Recording when:
– the recorder is recording or in timer recording standby.
– the HDD is not recordable.
– the HDD already contains the maximum number of titles (999).
HDD
DVR-433H_UK.book 49 ページ ２００５年３月１日 火曜日 午後５時６分