Pioneer DVR-433H-K - Manual (Page 19)

Connecting up 02
19
En
Connecting to an AV amplifier/receiver
To enjoy multichannel surround sound you need to connect this recorder to an AV amplifier/receiver using the digital
optical output.
In addition to a digital connection, we recommend also connecting using the stereo analog connection for
compatibility with all discs and sources.
You’ll probably also want to connect a video output to your AV amplifier/receiver. Use the ordinary video output (as
shown here), or the S-video output.
Important
• Noise may be output from your speakers if the recorder is not set up to work with your AV amplifier/receiver
properly (see Audio Out Settings on page 95).
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Connect one of the DIGITAL OUT OPTICAL jack on
this recorder to an optical digital input on your AV
amplifier/receiver.
This enables you to listen to multichannel surround
sound.
3 Connect the analog AUDIO OUTPUT and VIDEO
OUTPUT jacks on this recorder to an analog audio
and video input on your AV amplifier/receiver.
4 Connect the AV amplifier/receiver’s video output
to a video input on your TV.
Important
• Do not connect this recorder to your TV ‘through’
your VCR using A/V cables. Always connect it directly
to your TV.
TV
AV amp/
receiver
DIGITAL OUT CONTROL
IN
OPTICAL
AV 1 (RGB) – TV AV 2/AUTO START REC (INPUT 1/DECODER)
S-VIDEO VIDEO AUDIO
L R
COMPONENT VIDEO OUT Y P B
P R
IN OUT AC IN
OUTPUT S-VIDEO VIDEO AUDIO
L R
INPUT 3
ANTENNA
Antenna/cable TV
wall outlet
ANTENNA
IN
VIDEO
IN
DIGITAL
IN
AUDIO/VIDEO
IN
VIDEO
OUT
1
3
2
1
4
ANTENNA
IN (RF IN)
ANTENNA
OUT
DVR-433H_UK.book 19 ページ ２００５年３月１日 火曜日 午後５時６分