Petsafe Stay+Play Wireless Fence PIF00-12917 - Manual (Page 14)

14 1-800-732-2677 www.petsafe.net 15
5. Check the tightness of the Receiver
Collar by inserting one finger between
the end of a Contact Point and your pet’s
neck. The fit should be snug but not
constricting (6B).
6. Allow your pet to wear the collar for
several minutes then recheck the fit.
Check the fit again as your pet becomes
more comfortable with the Receiver
Collar.
7. Trim the collar as follows (6C):
6B
a. Mark the desired length of the
Receiver Collar with a pen. Allow for
growth if your pet is young or grows
a thick winter coat.
b. Remove the Receiver Collar from
your pet and cut off the excess.
c. Before placing the Receiver Collar
back onto your pet, seal the edge
of the cut collar by applying a flame
along the frayed edge.
6C
To Re-Thread the Collar
Slide Buckle
Ridges
The slide buckle prevents the collar from becoming loose
around your pet’s neck.
The ridges must be facing up; the collar will slip if it is
not properly threaded.