Petsafe Stay+Play Wireless Fence PIF00-12917 - Manual (Page 10)

10 1-800-732-2677 www.petsafe.net 11
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. Press the Mode Button and release (3B) when the Receiver Indicator Light
illuminates Red (3C).
2. The Receiver Indicator Light will emit a series of Red flashes representing the Static
Correction Level.
3. Increase the Static Correction Level by pressing and releasing the Mode Button
within 5 seconds of the previous series of flashes.
The Static Correction levels increase in strength from 1 to 6. Pushing the Correction
Level Button while the Receiver Collar is on level 6 will cause the Receiver Collar
to revert to level 1. Refer to the Function and Response Table to choose the Static
Correction level that best fits your pet.
Function and Response Table
Indicator Light
Response
Static
Correction
Level
Receiver Collar Function Temperament of Pet
1 Red Flash 1 No Static Correction, Tone Only Initial Training Mode
2 Red Flashes 2 Low Static Correction Timid
3 Red Flashes 3 Medium-Low Static Correction Timid or Average
4 Red Flashes 4 Medium Static Correction Average Energy
5 Red Flashes 5 Medium-High Static Correction Average or High
Energy
6 Red Flashes 6 High Static Correction High Energy
Over Correction Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this
feature limits the Static Correction duration to 15 seconds. While the system locks out
further Static Correction, the green light will remain on for 10 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static
Correction upon return to the Pet Area.