Pelco ESPRIT ES3012 - Manual (Page 21)

Pelco Manual C306M-K (4/05) 21
DIRECTION
Direction programs the horizontal display position of the Direction label (N, NW, NE, …).
The following settings are available for the Direction label:
Off – Label is not displayed.
Left – Label is displayed on the left-hand side of the screen.
Center – Label is displayed in the center of the screen.
Right (default) – Label is displayed on the right-hand side of the screen.
To program the horizontal label position for Direction:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Direction.
7. Press the Iris Open button. The cursor moves to the right.
8. Move the joystick up or down to view the available selections.
9. SELECT – Press the Iris Open button to make a selection.
CANCEL – Press the Iris Close button to cancel a selection.
Other Menu
Park Time 0
Pan/Scan Spd 7
Power Up Default
Pat length 6 min
Spd Profile 50 MPH wind
Exit
Az/El/Direction
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Disp Duration
Exit
MAIN MENU
EXIT
NOTE: For direction to be
accurate, the azimuth zero
must be set to magnetic
north.
NOTE: Direction display is
not available while you are
programmming or running a
pattern.