Polycom 3150-30828-001 - Manual (Page 6)

Polycom® RSS™ 4000 Getting Started Guide – Version 5.0
3
Plug Acts as Disconnect Device:
 The socket outlets to which this apparatus is connected must be installed near the
equipment and must always be readily accessible.
 In order to fully isolate the equipment then both power cords should be disconnected
otherwise the system will remain energized.
Initial
IP Address:192.168.1.254
Subnet Mask: 255.255.255.0
e system:
 able

cable
ble to LAN1 in the Polycom® RSS™ 4000.
ent of the Polycom® RSS™ 4000.
For example (in your laptop IP config setting):
Polycom® RSS™ 4000 IP Configuration
The system is shipped with a default IP configuration:
Gateway: 192.168.1.1
There are two ways to change the initial IP address of th
Via a cross over LAN c
Via a RS232 or Telnet Console.
Changing the initial IP address via a cross over LAN
1 Connect a cross over LAN ca
2 Set your laptop to the same segm