Panasonic 8045 - Manual (Page 42)

42
Internet Fax Features
Pre-Installation Information/Features
Before setting up your Panasonic machine on your network, please read this entire section to be familiar with its functions.
Your machine is able to perform the following when connected to a 10Base-T/100Base-TX Ethernet LAN (local area network):
• Send paper-based information as an Internet Email.
• Send Internet fax message (Direct IFAX XMT).
• Receive and print an Internet Email automatically.
• Forward received G3 fax message or Email automatically to the preprogrammed Email address or regular G3 fax machine (see
"Fax Forward" on page 142).
• Route received G3 fax message automatically to the sender-specified Email address or G3 fax machine using ITU-T SUB-
Address (see "Inbound Routing" on page 140).
• Route received G3 fax messages automatically to the preprogrammed Email address or G3 fax machine using the sender's fax
ID code (see "Inbound Routing" on page 140).
• Relay an Internet Email to a G3 fax machine via regular fax transmission (see "Relayed Transmission" on page 146).
• Scan to Email.
To utilize the above functions, your machine needs to be set up properly on your network. Please contact your network
administrator for actual network setup.
Copy the Pre-installation Information form found at the end of this section on page 46, record the MAC Address on the form, and
ask your network administrator to complete the remaining information on the form. The MAC Address of your machine can be
found on the 2nd page of the General Settings List printout.
To print the General Settings List, follow the steps below:
Press Function key, "GENERAL SETTINGS", "Key Operator Mode" , Enter Password, "OK" .
"Printing General Settings", "Start", "OK".