Printek FORMSMASTER 8000SE - Manual (Page 59)

P R I N T E R C O N F I G U R A T I O N
51
Interface Menu
The Interface Menu may contain several submenus. These submenus are
for setting up items pertaining to the hardware interfaces such as the serial
and parallel ports as well as the optional 10/100BaseT Ethernet or the
Wireless Print.
The Setup items for each interface are described in one of the following
sections.
RS-232C Serial Interface on page 52
Parallel/LAN Interfaces on page 57
Entering the Interface Menu
To Enter the Interface Menu, enter Setup and press the MENU button until
INTERFACE MENU is displayed on the top line as shown below.
INTERFACE MENU
Serial
The SUBMENU options for the INTERFACE MENU always include the
Serial and Parallel ports. The other ports mentioned earlier will only be
displayed if they are installed in the printer. This is also true of the Imager
or ImagerPlus graphics options. To select the desired interface, press the
SUBMENU button until that interface is displayed on the bottom line. Next
press either of the ITEM buttons to begin displaying the items associated
with that interface. Each interface and the items which pertain to that
interface are listed on the following pages. Note that many items are the
same for more than one interface since the computer attached to that
interface may have different requirements for each of those items.
The factory default values are indicated with an asterisk (*) in this manual
(the asterisk does not appear on the printer’s display).