Printek FORMSMASTER 8000SE - Manual (Page 33)

D A I L Y O P E R A T I O N
25
and the bottom line of the display will show
the path(s).
FORM FEED:
•
If a form is currently loaded and perhaps
partially printed, this button will advance the
bottom of the current form to the tear bar so
that it may be torn off.
•
If a form has already been advanced to the
tear bar, this button will advance the next
form to the tear bar.
FORM SELECT
/UNLOAD
This button is used to access up to ten different
forms which have been previously configured
with the Setup menus (see the chapter on Printer
Configuration for more information).
When this button is pressed, one of two functions
will be performed.
UNLOAD:
•
If a form is currently in position to be
printed, this button will pull the form down
until the top of the form is below the top of
the tractors. In the FormsMaster 8003se
this will also cause the tractor shuttle to
move forward for easy access to all tractors.
FORM SELECT:
•
If the form has already been pulled down to
the tractors as described above, this button
will cycle through all the available form
choices. Forms which are not considered to
be “loaded” in the tractors will flash
< not
loaded > on the bottom line of the display.
In the FormsMaster 8003se the not loaded
message will alternate with the tractor path
assigned to that form. For more information,
see the following section on “
Selecting and
Loading Forms ”.