Printek FORMSMASTER 8000SE - Manual (Page 23)

G E T T I N G S T A R T E D
15
Loading Paper
When shipped from the factory, the basic configuration for all ten forms is
an eleven inch form, six lines per inch, and ten characters per inch. If the
forms you are loading do not match these requirements, please refer to the
“
PRINTER CONFIGURATION ” chapter on page 41 and review the
“ Introduction to Setup ” and “ Forms Menu ” sections.
Please refer to the appropriate section below for loading paper in the
FormsMaster 8000se or FormsMaster 8003se.
FormsMaster 8000se Single Tractor Model
1. Make sure the printer is powered on and that the printer is off line
(ONLINE indicator flashing red).
2. Lift open the paper door on the front of the printer to expose the
paper feed tractors as shown below.
FormsMaster 8000se Tractors
3. Open the doors on each tractor.
4. Feed the paper up through the bottom of the printer and position the
holes in the edge of the paper over the pins in the left tractor while