PVI Industries PV 9-A - Manual (Page 2)

PV 9 8/05 817-335-9531 ● 800-433-5654 ● FAX 800-880-2019 ● www.pvi.com
START-UP REPORT
OIL FIRED NON-CONDENSING WATER HEATERS
MAXIM
®
- TURBOPOWER
®
Warning: Startup must be performed by a qualified service installer, service agency or the gas supplier.
Model Number: Serial Number:
Job Name:
Address:
GENERAL INFORMATION
Restart?
Yes No Installation is: New Replacement/Renovation Indoor Outdoor
Primary operating voltage: VAC Voltage from neutral to earth ground: (should be zero)
Lower Thermostat Setpoint: °F Upper Thermostat Setpoint: °F Hi-Limit Setpoint °F
T & P Relief Valve(s) plumbed to a suitable drain? Yes No
WATER HEATER INSTALLATIONS
Type of piping connected to heater: Copper Brass Galvanized
Is there a check valve in the supply water piping? Yes No
Is there a water softener on the cold water supply? Yes No Operational? Yes No
Is there a mixing valve on the hot water supply? If yes; temperature setting: °F No
Is there expansion relief in the cold water supply? If yes, what type: tank valve No
Is there a recirculation loop? Yes Circulating pump horsepower: No
Is there a floor drain in the room? Yes No
VENTING and COMBUSTION AIR
Vent Material: Vent Type: Through-the-roof Through Sidewall
Vent Diameter: inches; Vent Length: feet Does vent have elbows? Yes; Qty No
Does vent have condensate drain? Yes No
Does vent contain any of these devices? Power Vent Draft Inducer Draft Regulator Flue Damper
Combustion air louvers or openings? Yes; Qty: Size: No Interlocked? Yes No
Have direct-ducted combustion air? Yes; duct diameter inches, Duct length feet. No
Duct Material: Does duct have elbows? Yes; Qty No
Page 1 of 2