Paxar Monarch 9805 - Manual (Page 8)

L o a d i n g R i b b o n
If the ribbon reels continue to turn when you change a ribbon, press
Pause to stop the reels from turning. You can also change the ribbon
when the printer is turned off.
1. Open the cover.
2. Unlock the printhead by turning the retaining latch.
3. Lift printhead assembly using the printhead tab until the assembly
locks into place.
4. Push the deflector tab down.
5. Slide the extra ribbon core on
the take-up reel as far as it
will go with the "Monarch
This End Out" writing facing
out. Use your empty ribbon
core as the take-up core.
The take-up core only fits on
the take-up reel one way.
(An extra take-up core is
available by ordering part
number 117961.)
6. Remove the new ribbon from the package. Do not wrinkle or crush
the new ribbon.
7. Slide the ribbon onto the back reel as far as it will go. The ribbon
roll only fits on the reel one way. Carefully unwind a few inches of
ribbon from the bottom of the roll.
8. Carefully feed the ribbon under both ribbon rollers and printhead.
9. Align the ribbon and make sure it is straight and centered throughout
the path.
Deflector
Tab
6