beautypg.com

Troubleshooting – Philips DECT515 User Manual

Page 60

background image

Troubleshooting

59

http://www.philips.com/faqs/dect

Troubleshooting

The icon

does not

scroll when the handset is
placed on the base

PROBLEMS

No dialling tone

- Crackling on the line

The handset displays ‘not
available’

- when attempting to add
another handset to the base
station
- when using a handset

Noise interference on your
radio or television

Caller Line Identification (CLI)
service does not work

No ring tone

The icon

does not appear

The icon

is blinking

- Bad battery contact
- Dirty contact

- Battery is full

CAUSES

- No power

- Batteries are empty

- You are too far from the base station
- Wrong cable
- Line adaptor not plugged to the
line cord
- The ring tone is deactivated
- The Do not Disturb mode is ON

- No mains power
- The handset is too far from the
base station

- Handset not registered to the
base station

- You are too far from the base
station
- The base station is too close to
electrical appliances, reinforced
concrete walls or metal door-
frames

- The procedure to add a handset
has failed, try again
- Maximum number of handsets (6)
has been reached

- Base station is already busy with
another handset (ie : phonebook)

The DECT 511/515 base station or
mains power pack are too close to
electrical appliances

- The service is not activated

- Move the handset slightly
- Clean the contact with a cloth
moistened with alcohol
- No need to charge

SOLUTIONS

- Check the connections. Reset
the phone : unplug and plug back
in the mains
- Charge the batteries at least 24
hours
- Move closer to the base station
- Always use the cable provided
- Plug the line adaptor to the line
cord
- Increase the volume (page 50)
- Deactivate it (page 48)

- Check connections
- Move closer to the base station

- Register the handset to the base
(page 28)

- Move closer to the base station

- Move the base station to find a
better place (the higher the
better)

- Disconnect and connect the
base station power supply. Follow
the procedure to register a
handset (page 28)
- Un-register a handset

- Wait until it is available

Move the power pack or base
station as far as possible

- Check your subscription with
your network operator

Telephone troubleshooting

www.philips.com/support

DECT511_GBIE_part2_indice2_internet.qxd 26/10/2004 14:42 Page 25

This manual is related to the following products: