Philips DECT515 - Manual (Page 55)

Base station 54
http://www.philips.com/faqs/dect
Base station
Enable registration
Line settings
Service code settings
This feature allows you to register a DECT peripheral without keypad. Some DECT peripherals,
such as repeaters, do not have any keypad.A special menu-operated procedure is used to register
such peripherals to the base station.Also use the peripheral instructions to register it to the base
Enable registration
Line settings
Press to enter the carousel menu
Scroll to Base station and select
Press to select Enable registration
Enter the peripheral code (RC code) and press OK
Follow the instructions in the peripheral manual
To register a DECT peripheral
To change the dial mode
Press to enter the carousel menu
Scroll to Base station and select
Scroll to Line settings and select
Press to select Dial mode
Press to select Tone or scroll to Pulse and select
Note: this setting allows you to select pulse dialling (also called “Loop disconnect” and used in
countries without DTMF tone dialling capability or using old PABX)
DECT511_GBIE_part2_indice2_internet.qxd 26/10/2004 14:42 Page 20