Understanding auto-equalizing error, Messages, Nderstanding auto-equalizing error messages – Pioneer MULTI-CD CONTROL DSP HIGH POWER CD/MD PLAYER WITH FM/AM TUNER FH-P8900MD User Manual
Page 49
48
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
U
nderstanding auto-equalizing error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto-
equalizer, an error message may appear on the display. If an error message appears on the display,
refer to the table below to see what the problem is and the suggested method of correcting the prob-
lem. After checking, try again.
Display
Cause
Remedy
ERROR CHECK MIC
Microphone is not connected.
Plug the supplied microphone
securely into the jack.
ERROR CHECK SPEAKER
The microphone cannot pick
Confirm that the speakers are
up the measuring tone of the
connected correctly.
front and rear speakers.
Correct the input level setting of the
power amp connected to the
speakers.
Set the microphone correctly.
ERROR CHECK SYSTEM
The surrounding noise level
Stop your car in a place that is as
is too high.
quite as possible, and switch off the
engine, air conditioner or heater.
Set the microphone correctly.