Pioneer MULTI-CD CONTROL DSP HIGH POWER CD/MD PLAYER WITH FM/AM TUNER FH-P8900MD - Manual (Page 36)

35
Audio Adjustments
U
sing time alignment
The time alignment lets you adjust the distance
between each speaker and the listening posi-
tion to match the type of car. There are five
types of car stored which you can easily recall
at any time.
1. Press AUDIO and NEXT and then press
T.AL1 to select the time alignment mode.
2. Press the corresponding button to select
the type of car.
Button Type of car
SEDAN Sedan
WAGON Wagon
M.VAN Mini van
SUV Sports utility vehicle
CUSTM Custom
• “Custom” is an adjusted time alignment
that you can create for yourself.
Adjusting time alignment
For “Custom” time alignment, you can adjust
the distance between each speaker and the
selected position.
1. Press AUDIO and NEXT and then press
T.AL2 to select the time alignment adjust-
ment mode.
2. Press the corresponding button to select
a unit of distance.
Button Unit of distance
cm Centimeter
inch Inch
3. Press
2
or
3
to select the speaker to be
adjusted.
Each press of
2
or
3
selects speakers in
the following order:
Front Left (front left)
Ô
Front Right (front
right)
Ô
Rear Right (rear right)
Ô
Rear
Left (rear left)
Ô
Sub. W (subwoofer)
• You cannot select “SUB.W” when the sub-
woofer output is off.
• You cannot select “Sub. W” when you
select “REAR” in the preout output setting
mode (refer to page 41).
4. Press
5
or
∞
to adjust the distance
between the selected speaker and the lis-
tening position.
Each press of
5
or
∞
increases or decreas-
es the distance.
• “400.0cm” – “0.0cm” is displayed as the
distance is increased or decreased, if you
have selected centimeters (cm).
• “160inch” – “0inch” is displayed as the dis-
tance is increased or decreased, if you
have selected inches.
• You can adjust the distance for the other
speakers in the same way.
Note:
• “T.AL2” is not displayed when neither “FL” or “FR”
is selected in the position selector mode (POSI). If
“FL” or “FR” is not selected, “T.AL2” is inactive.
U
sing subwoofer output
This product is equipped with a subwoofer out-
put which can be switched on or off. When a
subwoofer is connected to this product, turn the
subwoofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1. Press AUDIO and NEXT and then press
SW1 to select the subwoofer output
mode.
2. Press SW1 to turn the subwoofer output
on.
“SUB. W ON” appears in the display.
• Press SW1 again to turn subwoofer output
off.
3. Press
2
or
3
to select the subwoofer
output phase.
Press
2
to select reverse phase. Press
3
to
select normal phase.