Pioneer MULTI-CD CONTROL DSP HIGH POWER CD/MD PLAYER WITH FM/AM TUNER FH-P8900MD - Manual (Page 42)

S
witching the telephone
muting/attenuation setting
Sound from this product is muted or attenuated
automatically when a call is made or received
using a connected cellular telephone.
1. With the source turned off, press and
hold 1.
2. Press MUTE.S to select the telephone
muting/attenuation mode.
3. Press MUTE.S to select the desired set-
ting.
Press MUTE.S repeatedly to switch between
the following settings:
TEL mute
=
10dB ATT
=
20dB ATT
• “20dB ATT” has a stronger effect than
“10dB ATT”, and “TEL mute” has a
stronger effect than “20dB ATT”.
Note:
• The sound turns off, “MUTE” or “ATT” is displayed
and no audio adjustments, except volume control,
are possible.
• Operation returns to normal when the phone call is
ended.
S
etting preout output
This product is equipped with a preout output. It
can be used for subwoofer or rear output.
Initially, it is set for SW (subwoofer).
When connecting a rear speaker to this output,
set for REAR (rear speaker).
1. With the source turned off, Press and
hold 1.
2. Press NEXT and then press PREOUT to
select the preout output setting mode.
3. Press SW (subwoofer) or REAR (rear
speaker) to switch your desired preout
output type.
S
etting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press FMstep to
select the FM tuning step mode.
3. Press the corresponding button to select
the desired tuning step.
Button Tuning step
50K 50 kHz
100K 100 kHz
Note:
• If seek tuning is performed in 50 kHz steps, stations
may be tuned in imprecisely. Tune in the stations
with manual tuning or use seek tuning again.
S
etting the AM tuning step
The AM tuning step can be switched between 9
kHz, the preset step, and 10 kHz. When using
the tuner in North, Central or South America,
reset the tuning step from 9 kHz (531 – 1,602
kHz allowable) to 10 kHz (530 – 1,640 kHz
allowable).
1. With the source turned off, press and
hold 1.
2 Press NEXT and then press AMstep to
select the AM tuning step mode.
3 Press the corresponding button to select
the desired tuning step.
Button Tuning step
9K 9 kHz
10K 10 kHz
41
Initial Settings Initial Settings