POLAR S510 - Manual (Page 52)

Display texts
CONNECT: Communication mode
between wrist receiver and
computer.
Cont: Up to 30 intervals succeed
one another unless the Interval
phase is manually stopped.
CoolDown: Cool-down phase at
the end of an interval training
exercise.
E0: BasicUse settings.
E1-E5: Indicates which exercise set
you have used for the exercise.
ExeSet: Start setting your BasicSet
(Int off) or Interval Training Set (Int
on).
Exe. Time: Exercise duration.
FILE: Indicates the file mode.
FIT. TEST: Indicates fitness test mode.
M 101
ALARM: Indicates the alarm in
watch settings.
AM or PM: Are used in 12h time
mode. E.g. in 24h time mode 13:00
means 1:00 PM.
AVG: Together with a reading
indicates average heart rate.
b0: Indicates that you have no bike
settings on.
b1: Indicates bike 1 setting.
b2: Indicates bike 2 setting.
BasicUse: Exercising without
settings.
BestLap: Indicates the shortest lap
time information.
Cad*: Indicates pedalling speed
measured in rounds per minute
(RPM).
M 100
Display symbols
Indicates an ongoing heart rate measurement and flashes to the beat of
your heart.
Indicates there has not been heart rate reception for less than 5 minutes.
- - Indicates there has not been heart rate reception for at least 5 minutes.
Options mode: indicates that you are setting the bike functions
Exercise mode: indicates that bike 1 or 2 is on.
File mode: indicates speed,cadence or distance information.
In the Time of day display the alarm is on.
Measure mode: beeps if you are exercising outside your target heart rate
zone. Fitness Test mode: sounds an alarm at the end of the fitness test.
Indicates the Interval Trainer.
Indicates continuous interval (Cont).
Exercise mode: indicates the heart rate above the target zone.
File mode: indicates the time spent above the target zone.
Exercise mode: indicates the heart rate below the target zone.
File mode: indicates the time spent below the target zone.
The graphic bar consists of five blocks. A flashing block indicates in
which level you are in the Options settings or File recalling loops.
Continuously running bars indicate that the exercise is recorded.
Indicates low battery.
*Optional Polar Cadence Sensor required
Manual S510 GBR C.pm6 8.3.2001, 12:44 100-101