Premier Mounts CTM-MS2 User Manual

Page 16

Text mode
Original mode

CTM-MS2

Page16

Installation Manual Page

Tilt the flat panel and secure the two (2) M6 x 12mm safety knobs to each of the mounting brackets
(Figure 19).

NOTE:

To remove the display from the wall simply extend the display to its maximum tilt range, remove
the two 6 (mm) safety knurl knobs push the flat panel back to it’s flat position, loosen or remove
the two (2) M6 x 30 lateral shift screws and lift the unit of the wall.

Figure 19

NOTE:

Although not depicted in the illustrations shown above, the width of this wall mount will
encompass four wall studs (three studs if 24” apart).