beautypg.com

Preparing and setting the window, Rough opening preparation (continued) – Pella 81470102 User Manual

Page 4

background image

2

PREPARING AND SETTING THE WINDOW

A. Install exterior jamb covers. Apply sealant along the leg of the jamb frame cover(s). Apply

a bead of sealant to the top corner of the bottom frame expander. Drive the short leg of the
jamb frame cover into the accessory groove using a block of wood with rounded edges and a
hammer. The notched end of the jamb cover goes toward the sill.

Sealant Bead - Along Flange

Sealant along leg of

Square Jamb Cover

Notched end of Square

Jamb Cover

Square Jamb Cover

1

ROUGH OPENING PREPARATION (CONTINUED)

J. Apply sill flashing tape #2. Cut a piece of flashing tape 12"

longer than the opening width. Apply at the bottom, overlapping
tape #1 by at least 1". DO NOT allow the tape to extend past the
interior face of the opening.

Note: The flashing tape may not fully cover the
framing members.

K. Install and level sill spacers. Place 1" wide by 3/8" thick spacers

on the bottom of the opening 1" from each side and every 16"
on center. Add shims as necessary to ensure the spacers are level.
Once level, attach spacers and shims to prevent movement.

1"

1J

1K

Angle Jamb Cover

If using Square Jamb Cover , Proceed to Step 2A.

If using Angle Jamb Cover , Proceed to Step 2B.

Square Jamb Cover

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL

ALL