Pioneer DVR-440H-S - Manual (Page 121)

The Initial Setup menu 14
121
En
DTS Out On • Output a DTS signal when a DTS source is being
played.
Off Switch off the digital output when a DTS source is
being played. Use when your connected equipment
doesn’t have a DTS decoder. In this case, use the
analog audio outputs.
96 kHz PCM Out 96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz out-
put. Use if your connected equipment doesn’t sup-
port 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is
being played.
MPEG Out MPEG Output an MPEG audio signal when a source using
MPEG audio is being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM out-
put. Use if your connected equipment doesn’t have
an MPEG audio decoder.
Audio DRC On Switches on Audio DRC (Dynamic Range Control).
Use when listening to Dolby Digital material at low
volume.
Off • Switches off Audio DRC.
Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby
Digital .
Language
OSD Language English • Sets the language of the on-screen displays to
English.
available languages Choose from the languages displayed for the on-
screen displays.
Setting Options Explanation
DVR540H_WV_EN.book 121 ページ ２００６年２月１６日 木曜日 午後４時３４分