Operating your p 3 continued, Adjusting bass and treble tone, Phones jack – Parasound P 3 User Manual

Page 21

OPERATING YOUR P 3 continued

Adjusting Bass and Treble Tone

Tone Button

Pressing the

Tone

button on the front panel or remote control turns on the tone

display. The illumination around the

Bass

and

Treble

buttons will also brighten. After

pressing the

Tone

button, you have about five seconds to make adjustments.

< Bass > Buttons

Press the

Tone

button once to display the present bass boost or cut.

Keep pressing the

Bass

< or > button until you reach the desired bass level.

After about 5 seconds, the display will revert to show source and volume level.

< Treble > Buttons

Press the

Tone

button once to display the present treble boost or cut.

Keep pressing the

Treble

< or > button until you reach the desired treble level.

After about 5 seconds, the display will revert to show the source and volume level.

Phones Jack

Connect your stereo headphones to this standard 1/8” jack. The outputs of the P 3
are still active when you connect a headphone.

YOU SHOULD KNOW

If you want to listen to the headphones with no music playing through your speakers, you will
need to turn off your power amplifier manually.

Remote Control Handset

The P 3 remote control handset controls the following functions from up to 25’
(8 meters) away:

On
Off
Volume increase
Volume decrease
Mute
Source Select
Tone on/off (but not actual tone adjustment)

For your convenience, it also controls the Parasound T 3 Tuner.

The remote uses two standard AAA batteries that are included. Make sure you insert
the batteries in the direction indicated on the molded battery compartment. When the
batteries wear out, please recycle them and replace them only with alkaline type batteries.

See page 19 for P 3 Front Panel and Remote Control layout