Operating your p 3 continued, Selecting the input source, Adjusting the balance level – Parasound P 3 User Manual

Page 20

OPERATING YOUR P 3 continued

Selecting the Input Source

You can select the input source by repeatedly pressing the

Source

button on the front

panel until the desired source name appears in the status display. You can also select
the desired source directly with the

Source

select buttons on the remote control.

The

Source

buttons on the remote control correspond to the following:

Remote Control Button Input

Direct 1

Direct 2

Aux (line or phono selected at rear panel)

Tuner

Tape

Selecting the Input Source on the P 3

Press the front panel

Source

button until the desired input source is selected. You can

also press the

Source

buttons on the remote control.

Adjusting the Balance Level

You can adjust the balance of the P 3 with the <

Balance

> buttons on the front panel.

Each press of a button in either direction increases the relative balance in 2 dB increments

Adjusting Balance toward the Right Channel

Press the

Balance

> button once to show the present balance level in the display.

The next time you press the

Balance

> button it will change the balance.

Keep pressing the

Balance

> button until the desired balance is reached. Each time

you press the

Balance

> button, the right channel level will increase by 2 dB.

Adjusting Balance toward the Left Channel

Press the <

Balance

button once to show the present balance level in the display.

The next time you press the <

Balance

button it will change the balance.

Keep pressing the <

Balance

button until the desired balance is reached. Each time

you press the <

Balance

button, the left channel level will increase by 2 dB.

See page 19 for P 3 Front Panel and Remote Control layout