Adjusting loudness 33 using subwoofer output 33, Adjusting subwoofer settings 33, Audio adjustments – Pioneer KEH-P7020R User Manual
Page 33: Adjusting loudness, Using subwoofer output
Audio Adjustments
En
33
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press
AUDIO
to select
Loud
.
Press
AUDIO
until
Loud
appears in the display.
2 Press
5 to turn loudness on.
Loudness level (e.g.,
Loud Mid
) appears in the
display.
3 Press
2 or 3 to select the level.
Press
2 or 3 until the desired level appears in
the display.
Low
(low)—
Mid
(mid)—
High
(high)
4 Press
∞ to turn loudness off.
Loud OFF
appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press
AUDIO
to select
Sub-W1
.
When the subwoofer controller setting is
S.W
Control:EXT
, you cannot select
Sub-W1
. Press
AUDIO
until
Sub-W1
appears in the display.
2 Press
5 to turn subwoofer output on.
Sub-W1 Normal
appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
3 Press
2 or 3 to select the phase of sub-
woofer output.
Press
2 to select reverse phase and
Rev.
appears in the display. Press
3 to select normal
phase and
Normal
appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press
AUDIO
to select the
Sub-W2
.
When the subwoofer output is on, you can
select the
Sub-W2
. Press
AUDIO
until
Sub-W2 80
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
50
(Hz) or
125
(Hz).
2 Press
2 or 3 to select cut-off frequency.
Press
2 and
50
(Hz) is displayed. Press
3 and
125
(Hz) is displayed. Only frequencies lower
than those in the selected range are output
from the subwoofer.
3 Press
5 or ∞ to adjust the output level of
the subwoofer.
Each press of
5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
+6
to
–6
).
Press
5 or ∞ until you see the desired value
displayed.
English
Español
Deutsch
F
rançais
Italiano
Nederlands
07
Section