Primera Technology LX 810 - Manual (Page 25)

Supplies and Driver Settings 21
Sensor Type
Sensor Type refers to the method the printer will use to center
the print image on your label material. If you are using
standard die-cut labels or Through-hole label material where a
hole is punched through each label for alignment purposes use
the Through-hole/Die-Cut setting. Use Reflective for black
stripe sensing label material where a pre-printed line indicates
the break between labels. If you have continuous stock with no
die-cut or reflective mark, set the sensor type to Continuous.
Rewinder Mode
This defaults to No. When set to no, the printer will align your
labels with the tear off bar for easy removal. This mode can be
set to Yes when using the printer with an automatic rewinder.
Enable Bi-di Printing
This setting defaults to Yes for fastest printing. When enabled
you will be required to perform an alignment print after a new
cartridge is installed. If you would like to bypass cartridge
alignment set this setting to No and set the Cartridge Type set-
ting to Color. You will now be able to skip the alignment print
after changing cartridges.
TOF Offset
TOF stands for Top of Form and this setting allows you to fine
tune the alignment of your printing on your label stock. This
will be factory calibrated. If fine tuning is needed, increase this
value to move the image down on the label. Decrease this value
to move the image up the label. The unit of measure is 0.1mm.
Tear Off Offset
If Rewinder Mode (described earlier in this section) is set to No,
the printer will present your labels over the Tear Bar for easy
removal. This is set at the factory. If fine tuning is needed to
align the break in your label stock over the Tear Bar, increase
this setting to eject the label further; decrease this setting to
eject the label stock less. The unit of measure is 0.1 mm.
510943.qxd 2/22/2006 10:35 AM Page 21
TOC INDEX