Philips FW-P73 - Manual (Page 24)

3139 116 19511 ( ENG)
24 RECORDING CLOCK
Dubbing tapes (from tape deck 2
to tape deck 1)
1 Load the prerecorded tape into tape
deck 2 and a blank tape into tape
deck 1.
• Make sure both tapes have their full
spool to the left.
2 Press PAUSE on tape deck 1.
3 Press RECORD on tape deck 1.
4 Press PLAYÉ on tape deck 2.
™ The REC starts flashing.
• Recording will start automatically.
5 Press STOP•OPEN on tape deck 1
and tape deck 2 to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 2 to tape deck 1.
– To ensure good dubbing, use tapes of
the same length.
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER,
etc.). The clock will be displayed for
about seven seconds.
• Press CLOCK/TIMER briefly.
™ “PM 10:38 or 22:38 ” (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™ “--:::::--” will be displayed if the
clock is not set.
Clock Setting
The clock can be set in either 12- or
24-hour mode, e.g. “
AM 12:00“ or
“ 00:00“. Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select
clock mode.
2 Press PROG (on the system only) to
select 12- and 24- hour mode.
™ If 12-hour mode is selected, “AM
12:00“ starts flashing.
™ If 24-hour mode is selected,
“ 00:00” starts flashing.
3 Set the hour with␣ à or á on the
system.
4 Set the minute with␣ í or ë on
the system.
5 Press CLOCK/TIMER again to
store the setting.
™ The clock starts.
TAPE CD
PROG
CLOCK/
TIMER NEWS!
RDS
DOLBY B NR STANDBY
ON
TUNER AUX
PRESET ▲ ▲
STOP • CLEAR SEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
C D 1 • 2 • 3 VIDEO FM • AM TAPE 1 • 2
VOLUME
S S
L R
C
PRO LOGIC
UP
DOWN
FRONT
SHUFFLE PROGRAM
FM
STEREO BACK HSD REPEAT REC LW MW AM T.A. NEWS TIMER
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
SOUND SOUND NAVIGATION
S S
L R
C
PRO LOGIC S S
L R
C
PRO LOGIC
DYNAMIC BASS
BOOST DIGITAL SOUND
CONTROL
Recording from other
sources
(only on tape deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to
start recording.
™ The
REC starts flashing.
4 Press PAUSE to interrupt
recording.
5 Press STOP•OPEN on tape deck 1
to stop recording.
Note:
– During recording, it is not possible to
listen to another sound source.