Pioneer PDP-LX508G - Manual (Page 51)

Using with other equipment 10
51
En
Eng
lis
h
3 Select “Playback Order” ( /).
4 Select “Name Order” or “Random” ( /).
5 Select “Repeat Mode” ( /).
6 Select “Single Time” or “Loop” ( /).
• With “Loop” selected, Slide Show is repeated until RETURN is
pressed.
7 Select “Playback Mode” ( /).
8 Select “Auto” or “Manual” ( /).
• With “Auto” selected, images automatically change at the
specified intervals.
• With “Manual” selected, images change each time you press
P+/P–.
9 If you have selected “Auto” in step 8, press / to select
“Interval (sec.)”, and then press / to select the desired
display duration for individual images.
• You can select from among 3 seconds, 5 seconds, 10 seconds,
20 seconds, 30 seconds, 60 seconds, and 90 seconds.
10 To start the Slide Show screen, press RETURN to display
the thumbnail screen and then press RED.
• To quit the Home Gallery function, press HOME MENU.
Starting the Slide Show screen
After setting up for Slide Show, you can start Slide Show to
sequentially change images.
1 To start the Slide Show screen, press RED when a
thumbnail screen is displayed.
• With “Auto” selected for “Playback Mode”, images
automatically change at the specified intervals.
• With “Manual” selected for “Playback Mode”, press P+/P– to
change images.
• While images are automatically changing, you can stop and
hold automatic image change for approximately 90 seconds by
pressing
RED. To resume, press RED again.
2 When quitting the Slide Show screen, press RETURN to
restore the thumbnail screen or HOME MENU to quit the
Home Gallery function.
Note
• When paused during a slideshow is played, the screen
automatically changes to the next image in five minutes.
• If no operation is continued for five minutes, the Home Gallery
function automatically finishes except when the slideshow is
played with “Loop” selected for the “Repeat Mode”.
Adjusting the picture quality
When a thumbnail screen is displayed, press YELLOW. The same
picture adjustment screen as the PC source is displayed. For the
subsequent procedure, see page 29.
Controlling other equipment using the
supplied remote control unit
Using the supplied remote control unit, you can control other
equipment in connection: a set-top box (STB), DVD player, DVD/
HDD recorder (DVR), BD player or VCR.
Before using this function, you need to preset the supplied remote
control unit with the manufacture code of the equipment to be
controlled. When you then want to control the equipment, press
SELECT on the remote control unit to select an appropriate mode
depending on the equipment; the selection is switched among TV,
STB, DVD/DVR, and VCR. The corresponding mode indicators on
the remote control unit show the currently selected mode.
• When you control a BD player, select the DVD/DVR mode.
Presetting manufacture codes
1 Press SELECT on the remote control unit to select the STB,
DVD/DVR, or VCR mode depending on the equipment.
2 After confirming that the indicator of the previously
selected mode goes off, press and hold SELECT, and then
press 1 on the remote control unit.
• The corresponding mode indicator flashes.
3 Press 0 to 9 to enter a three-digit manufacture code.
• See the manufacture code list to identify an appropriate code.
• The mode indicator lights up for approximately one second and
then goes off; presetting the manufacture code is completed.
Note
• If you perform no operation for approximately one minute while
a mode indicator is flashing, the code presetting procedure is
quitted.
Home Gallery
HOME MENU Exit
Display Mode
Slide Show Setup
Playback Order Name Order
Repeat Mode Single time
Playback Mode Auto
Interval (sec) 3
Normal