Pella 80GZ0102 - Manual (Page 3)

E. Apply sill flashing tape #1.
longer than the opening width. Apply at the bottom of the
OPENING
Note: The tape is cut 12" longer than the width so that it
will extend 6" up each side of the opening.
A. Remove plastic wrap and cardboard packaging from window.
Note: If screens, grilles or hardware are removed from the
window at this time, label them and store them in a protected
area.
For installation using installation clips, preceed to Step C.
2
WINDOW PREPARATION
&
'
(
)
F. Tab the sill flashing tape and fold.
CORNER
'
!PPLY
PAST
Note: The flashing tape may not fully cover framing members.
H. Install and level sill spacers. Place
BOTTOM
Note: Improper placement of shims
or spacers may result in bowing the
bottom of the window.
C. Fold out installation fin to 90°. Be careful not to remove
or tear the fin corners.
Note: If the fin is not at 90°, the window will not line up
correctly on the interior.
B. Windows using frame screws:
Pre-drill installation screw holes.
On the room side of the window,
DRILL
OF
MAXIMUM
$MBE'SBNF4JMM
%SJMM
DMFBSBODFIPMF
#
6" MAX
6" MAX
10"
MAX
10"
MAX
10"
MAX
6"
MAX
10"
MAX
10"
MAX
6"
MAX
FOR PLACEMENT
OF FRAME
SCREWS AND
INSTALLATION
CLIPS
$
D. Windows using Installation Clips: Install installation
clips. Place the clip so that the lip is facing up and against
the installation fin, at the locations shown in the placement
DIAGRAM
6“ from end
Lip
#6 x 5/8” corrosion
2D
resistant screws