beautypg.com

Setting the high pass filter for rear, Speakers, Using the auto-equalizer – Pioneer Super Tuner III D DEH-P9850BT User Manual

Page 76: Using the equalizer, Recalling equalizer curves 76, Recalling equalizer curves, Setting the high pass filter for rear speakers, Audio adjustments

background image

Black plate (76,1)

50

—63—80—100—125—160—200 (Hz)

Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.

5

Push MULTI-CONTROL up or down to

adjust the output level of the front speak-
ers.
Each time

MULTI-CONTROL is pushed up or

down, the level of the front speakers increases
or decreases.

0 to

–24 is displayed as the level

is increased or decreased.

Setting the high pass filter for
rear speakers

1

Use MULTI-CONTROL to select

Rear HPF.
Rear HPF appears in the display.

2

Push MULTI-CONTROL left or right to

select slope.
Each time

MULTI-CONTROL is pushed left or

right, slopes are selected in the following
order:
–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter does
not have an effect.

3

Turn MULTI-CONTROL to select

Rear HPF FREQ.
Rear HPF FREQ. appears in the display.

4

Push MULTI-CONTROL left or right to

select cut-off frequency.
Each time

MULTI-CONTROL is pushed left or

right, cut-off frequencies are selected in the
following order:
50

—63—80—100—125—160—200 (Hz)

Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.

5

Push MULTI-CONTROL up or down to

adjust the output level of the rear speak-
ers.
Each time

MULTI-CONTROL is pushed up or

down, the level of the rear speakers increases
or decreases.

0 to

–24 is displayed as the level

is increased or decreased.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 80).
You can turn the auto-equalizer on or off.

1

Use MULTI-CONTROL to select Auto EQ.

Auto EQ appears in the display.

# Please set Auto EQ appears. This indicates
that you cannot turn the auto-equalizer on if auto
TA and EQ has not been carried out.

2

Press MULTI-CONTROL to turn the auto-

equalizer on.
ON appears in the display.

# To turn auto-equalizer off, press
MULTI-CONTROL again.

Using the equalizer

The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.

Recalling equalizer curves

There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:

76

Audio Adjustments

En

76

Section

13