Tuner listening to the radio, Listening to the radio, Tuner – Pioneer Super Tuner III D DEH-P9850BT User Manual
Page 16
Black plate (16,1)
Listening to the radio
4
4
4
4
3
3
3
3
5
5
5
5
2
2
2
2
1
1
1
6
6
6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 84).
1 Stereo (
5) indicator
Shows when the selected frequency is
being broadcast in stereo.
2 LOC indicator
Shows when local seek tuning is on.
3 Band indicator
Shows which band the radio is tuned to, AM
or FM.
4 Preset number indicator
Shows which preset has been selected.
5 Frequency indicator
Shows the frequency to which the tuner is
tuned.
6 Signal level indicator
Shows the radio wave strength.
1
Press SOURCE to select the tuner.
Press
SOURCE until you see Tuner displayed.
2
Press BAND to select a band.
Press
BAND until the desired band (FM-1,
FM-2, FM-3 for FM or AM) is displayed.
3
To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4
To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release
MULTI-CONTROL.
Tuner
En
16
Section
04